Messenger Wire
Messenger wire consists of high tensile strength stainless steel wire, which is wound around the Detector at the rate of approximately one turn per foot (0.3m).

Messenger wire is a high tensile strength 316 stainless steel wire that is wound around the linear heat detector at approximately one turn per foot (0.3m). Messenger wire is designed to simplify the installation of the detector in areas where mounting is difficult due to the lack of appropriate support structures or mounting surfaces.
When using messenger wire to support the linear heat detector, turnbuckles and eyebolts must be employed at each end of the stainless wire to apply tension to the detector run. The maximum detector run length between turnbuckles should not exceed 250 feet (76m) and the wire must also be supported with a recommended intermediate fastener range of 15 – 50 feet (4.5 – 15m). Intermediate fastener spacing should never exceed 50 feet (15m). Outdoor messenger wire installations present additional challenges due to environmental factors such as snow loads, ice build-up or wind. Increased detector support must be provided by using additional intermediate fasteners with closer spacing in all outdoor installations.
- Messenger wire (a Protectowire innovation), is available with any model Detector on special order.
